12
The clereance height between the inferior part of
the cooker hood and the hob must be 650 mm (
some models can be fitted at a lower height from
the hob, please refer to the installation paragraph).
Unpacking
The fittings supplied to install this cooker
hood can be found with the instruction book
inside the packaging.
The fixing of the frontal panel to the visor:
1 Pull out the metal visor and, at the same time, unlock
the lever on the left side of the hood.
2 Use the cardboard template when drilling the front
panel. Fix the panel to the visor using the screws not
supplied.
Wall fitting
The cooker hood is fitted to the wall using the
keyhole slots in the back of the hood.
1
Hood depth can vary from 275 to 360 mm.
2
Regulate the
Vx
screws when adjusting the brackets
to the right depth.
3
When adjusting the lower part of the hood to the
requested depth it is necessary to loose the screws
of the metal distance piece and to move it as much
as necessary.
4
Use the specific cardboard template when drilling
the holes into the wall. Put the dowels into the holes
and fix the two metal brackets using the four screws
not supplied together with other accessories.
5
Use the specific cardboard template when drillig the
side closets.
When the hood is used in ducting version it is necessary to
remove the grid from the air outlet.
6 Hang the hood on the metal brackets.
7 Put back the visor again paying attention that the
runners are put correctly into the proper places. Adjust
the visor sliding by means of the two screws.
8 Regulating the
Vy
screws it is possible to align the
hood height compared to the closets.
9 When necessary adjust again the hood depth.
10 Place the safety squares above the fixing brackets.
11 Mark the midpoint of the holes.
12 Drill the wall and fix the safety squares together with
screws and dowels (supplied).
����������
��
��
��
��
