Zanussi ZHC9454X, User Manual

Page: 10 / 28

10
Grease and charcoal filter maintenance
indicator
This hood is fitted with a device that indicates
when it is necessary to clean the grease filter or
the charcoal filter (if the hood is used in the
recirculation version with a charcoal filter).
On delivery, the hood is not supplied with a
charcoal filter, so the saturation indicator will be
disabled.
If the hood is to be used with a charcoal filter,
the saturation
indicator light must be enabled as follows:
Set in "OFF" the hood.
Press buttons 1 and 2 simultaneously and hold
them for 3 seconds. At first only the grease filter
LED 3 will light up, but when the charcoal filter
LED 4 lights up the saturation indicator will be
enabled.
To disable it: Press buttons 1 and 2 again
simultaneously and hold
them for 3 seconds, until the charcoal filter LED
4 goes out. Grease filter LED
LED 3 will start to flash when it is time to clean
the grease filter.
Cleaning will be necessary after 40 working
hours. Always comply with the maintenance
instructions for the grease filter.
Charcoal filter LED
The charcoal filter LED 4 will start to flash when
the charcoal filter needs to be replaced.
This operation is necessary after approximately
160 working hours.
Resetting the saturation indicator
After cleaning or replacing the filters, press
button 2 for 3 seconds until the grease filter LED
3 or the charcoal filter LED 4 stops flashing.