Zanussi ZHC 925, Instruction Booklet

Page: 7 / 20

7
Charcoal Filters
In the recirculation mode the charcoal filters
absorb smells and unwanted odours.
The charcoal filters cannot be cleaned or
regenerated, and must be replaced when the
Instensive speed LED T5 starts to flash, or at
least once every 3 months.
Attention: If, when used in the recirculation
mode both the T2 and T4 LED indicator lights
begin to flash simultaneously this indicates the
both the charcoal filter needs replacing and the
grease filters need cleaning.
Replacing the charcoal filter
First remove the metal grease filter GF
as illustrated in Fig. 1.
Carefully remove the screw from the
centre of the charcoal filter, while
holding the filter securely.
Clean the grille before replacing the
charcoal filter.
To replace the charcoal filter, place the
filter over the inlet grille and while
holding the filter with one hand insert
the screw and tighten by hand as
illustrated in Fig. 3.
This appliance can be a possible fire
hazard if the grease and charcoal filters
are not cleaned and replaced as
recommended.
Changing the Light Bulb
Unsrew the two screws from the frame
around the lamp lens as illustrated in
Fig. 4.
Remove the lamp by carefully pulling it
downwards until it clears the holder.
When replacing the lamp, ensure the
two pins are correctly positioned before
inserting the lamp into the holder by
applying carefull pressure to the lamp
lens.
If one of the halogen lamps has failed to
function check that the lamps is correctly
seated into the holder. If the lamp has failed
then it should be replaced with a 20W
spotlamp.
Replacement filters and light bulbs can be
obtained from your local Service Force
Centre.
Fig. 3
FA
Fig. 4