Zanussi ZGG75XA, User Manual

Page: 7 / 20

Burner overview
A
B
D
C
C
D
A
B
A. Burner cap
B. Burner crown
C. Ignition candle
D. Thermocouple
Ignition of the burner
Always light the burner before you
put on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
1. Push the control knob down and turn it
counterclockwise to the maximum gas
supply position (
).
2. Keep the control knob pushed for equal or
less than 10 seconds. This lets the
thermocouple warm up. If not, the gas
supply is interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and its
cap are in correct positions.
WARNING!
Do not keep the control knob
pushed for more than 15 seconds. If
the burner does not light after 15
seconds, release the control knob,
turn it into off position and try to light
the burner again after minimum 1
minute.
CAUTION!
In the absence of electricity you can
ignite the burner without electrical
device; in this case approach the
burner with a flame, turn the control
knob counter-clockwise to maximum
gas supply position and push it
down. Keep the control knob
pushed for equal or less than 10
seconds to let the thermocouple
warm up.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
The spark generator can start
automatically when you switch on
the mains, after installation or a
power cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the off
position .
www.zanussi.com 7