Zanussi ZGF 7521, Instruction Booklet

Page: 8 / 32

8
Lighting the burners Lighting the burners
Lighting the burners Lighting the burners Lighting the burners
For easier lighting, proceed before putting a pan on the pan For easier lighting, proceed before putting a pan on the pan For easier lighting, proceed before putting a pan on the pan For easier lighting, proceed before putting a pan on the pan For easier lighting, proceed before putting a pan on the pan
s u p p o r t .
s u p p o r t . s u p p o r t . s u p p o r t . s u p p o r t .
To light a burner:
z
turn the relevant knob anti-clockwise to maximum position ( ), then
push it down to ignite the burner.
z
Then, check that the flame is regular adjust it as required.
If the burner does not ignite, turn the control knob to zero, and try again.
If you cannot light the flame even after
severalattempts, check the "cap" (Fig. 1
lett. A
A
A A A) and the"crown" (Fig. 1 lett. B
B
B B B) are in
the correct position.
When switching on the mains, after
installation or a power cut, it is quite
normal for the spark generator to be
activated automatically.
In the absence of electricity In the absence of electricity
In the absence of electricity In the absence of electricity In the absence of electricity, ignition
can occur without the electrical device; in
this case, approach the burner with a
flame, push the relevant knob down and
turn it anti-clockwise until it reaches the
maximum position.
If the control knobs become difficult to
turn, please contact your local Service
Force Centre.
Operation
)
Fig. 1
A
- Burner cap
B
- Burner crown
C
- Ignition electrode