Environment Protection
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant cir-
cuit or insulation materials. The appliance shall not be
discarded together with the urban refuse and rubbish. The
insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations
to obtain from your local authorities. Avoid damaging the
cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the
symbol are recyclable.
Control panel
1
2
4
3
5
1
Alarm Light
2
Fast Freeze Indicator
3
Fast Freeze Switch
4
Pilot Light
5
Temperature Regulator
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
The Pilot light and the Alarm light will light up.
Switching off
To turn off the appliance, turn the Temperature regulator
to the " " position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings to
obtain the minimum coldness.
• turn the Temperature regulator toward higher settings
to obtain the maximum coldness.
The intermediate position is usually the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Fast Freeze function
To activate the Fast Freeze function, press the Fast Freeze
switch.
The Fast Freeze light will light up.
Excessive Temperature Alarm
In the event of an abnormal temperature rise inside the
freezer (e.g. power cut) alarm light comes on.
When normal conditions are restored the alarm light will
switch off automatically.
First use
Cleaning the interior
Before using the appliance for the first time, wash the inte-
rior and all internal accessories with lukewarm water and
some neutral soap so as to remove the typical smell of a
brand-new product, then dry thoroughly.
Important! Do not use detergents or abrasive powders, as
these will damage the finish.
14
