Zanussi ZFT11112WV, User Manual

Page: 12 / 16

2
1
6. Fit the appliance door on the upper door hinge
pin.
7. Remove the lower hinge. Put over the pin in the
direction of the arrow.
8. Unscrew and install the screw on the opposite
side.
9. Install the lower hinge on the opposite side
leaving the position of the door unchanged.
10. Screw in the one screw in the place set free on
the other side as well as the adjustable feet (2
pieces).
11. Remove and install the handle on the opposite
side.
1
2
3
4
CAUTION! Reposition, level the
appliance, wait for at least four hours
and then connect it to the power
socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold (i.e.
in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.
ELECTRICAL CONNECTION
CAUTION! Any electrical work
required to install this appliance
should be carried out by a qualified
electrician or competent person.
WARNING! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
The wires in the mains lead are coloured in
accordance with the following code:
A B
C
D
E
• A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
12