20
Check the position again by slackening the screws
and pins then, once the best position has been
obtained, fully tighten all the fixings.
Cover the visible part of the top bracket on the panel
with plastic cover (D), inserting it in the locations
provided in the bracket.
Once the door has been correctly aligned, tighten the
holding nuts on the fixing brackets and attach the
appliance to the adjacent units and the bottom of the
work surface (Fig. 11).
If the appliance has been fitted into a space 820 mm
high and the maximum height of the base plate is 100
mm, fit the front cover plate by pushing the two
vertical lugs into the rectangular holes on the bottom
side of the ventilation duct until they click. The plate
can be adjusted backwards or forwards in the holes
(Fig. 12).
If the base plate is between 100 and 135 mm high, cut
it as shown in Fig. 14 and mount as described above.
If the base plate is between 135 and 170 mm high, cut
it as shown in Fig. 12.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
D472
D
D517
135
185
170
220
600
820
870
D518
100
150
820
870
20÷80
D546
min.
50cm
2
