Zanussi ZDT40, User Manual

Page: 9 / 28

Water hardness Adjusting the water hardness
setting
Use of salt
Clarke °TH mmol/l manually electronically
18 - 22 26 - 32 2,6 - 3,2 1 level 4 yes
13 - 17 19 - 25 1,9 - 2,5 1 level 3 yes
5 - 12 7 - 18 0,7 - 1,8 1 level 2 yes
< 5 < 7 < 0,7 1 level 1 no
The water softener must be set in both ways:
manually, using the water hardness dial and
electronically.
Setting the water softener manually (see table)
Set switch to position 1 or
2
The water softener is factory set at position 2.
Setting the water softener
electronically (see table)
1. Press the On/Off button. The appliance
must be in setting mode .
2. Press and hold Programme selection/
Cancel button until programme light A
flashes and programme light B illuminates
with fixed light.
3. After a few seconds:
– programme light
B turns off
– programme light A goes on flashing
– End of programme light starts flashing:
the number of flashes corresponds to
current level set. The flashing is repea-
ted with a pause of a few seconds.
Examples: 5 flashes, pause, 5 flashes,
pause, etc... = level 5.
4. To change the level, press the Programme
selection/Cancel button. Each time the
button is pressed the level increases (level
1 follows level 10). The
End of pro-
gramme light indicates the new setting.
5. To memorise the operation, switch off the
dishwasher.
9