Water inlet hose with safety
valve
Connect the inlet hose to a water tap with an
external thread of 3/4”.
After connecting the double-walled water inlet
hose, the safety valve is next to the tap.
If the water inlet hose leaks, the safety valve
cuts off the water supply.
WARNING!
The electrical cable for the safety valve is in the
double-walled water inlet hose and is live.
Therefore do not immerse the water inlet hose
or the safety valve in water.
Take care when installing the water inlet hose
. Place the water inlet hose in such a way that
it is always lower than the bottom edge of the
safety valve.
If the water inlet hose or the safety valve is
damaged, remove the mains plug immediately.
CAUTION!
A water inlet hose with safety valve MUST only
be replaced by your local Service Force Centre.
Drain hose
Connect drain hose to the
sink.
Required height: 30 to 100
cm above bottom of the
dishwasher.
Ensure that the hoses are
not kinked, crushed or en-
tangled.
When connecting the
drain hose to an under
sink trap spigot,
the entire
plastic membrane (A)
must be removed
. Fail-
ure to remove all the mem-
brane will result in food
particles building up over
time eventually blocking
the dishwasher drain hose
spigot.
If you use a drain hose extension the total
length should not be longer than 4 metres.
Likewise the internal diameter of the couplings
used for connections to the waste outlet must
22
