Zanussi ZDS 689 EX, Instruction Booklet

Page: 32 / 36

Adjusting the door balance
The door of the dishwasher is balanced when it is open
in any position.
Fitting the decor panel may sometimes affect this
balance. In this case it will be necessary to adjust the
balance as follows:
Half-open the door and regulate the screws located on
the kick plate.
By screwing or unscrewing these screws, the tension of
the door balancing springs is increased or decreased
respectively.
The weight of the panel should be within the limits
given in "The furniture door" otherwise balancing the
door will not be possible.
Fixing to the adjacent units
To prevent the dishwasher tilting, it must be secured to
either the worktop or adjacent kitchen cabinet/wall using
the brackets supplied.
Insert the two fixing brackets into the slots provided in
the top front part of the dishwasher as shown in the
figure.
Secure the brackets to the adjacent units with the
3.5 x 16 screws using the upper or the side holes.
The appliance must be secured to the
underside of the worktop using the
brackets provided.
Failure to do this could cause damage
or injury.
32
PFI23UK
II08
II54