Symptom
Fault code
Solution
The machine will not start
■
The door has not been properly closed
(open door indicator light flashes).
■
The plug is not properly inserted in the
power socket.
■
Check the plug fuse.
■
There is no current at the socket.
The machine does not fill
Indicator light
■
Ensure the water tap is open.
with water
water tap
■
Ensure the mains water supply has not
flashes
been cut off.
■
The inlet hose may be squashed or bent.
Reposition the hose.
■
The inlet hose may be blocked.
Switch off the water supply, and clean
the filter.
The filters are blocked
Alarm A3
■
Clean the filters, refer to “Maintenance
flashes in the digital
and cleaning”.
display
■
The spray arms are not rotating. Ensure
the crockery is loaded correctly.
The dishwasher will not drain
Alarm A6
■
The drain hose may be squashed or
flashes in the digital
bent.
display
Reposition the hose.
■
The sink may be blocked. Clear any
blockages.
■
The drain hose extension is not correct.
Follow the instructions for connecting to
the waste.
■
There is no vent in the end of the drain
hose.
General
Alarms A1, A2, A7
■
Switch off the dishwasher.
Switch it back on and start the
programme.
If the alarm reappears, call the local
Service Force Centre.
The machine is noisy
■
Dishes are rattling against each other,
refer to “Loading your machine”.
■
The spray arms are knocking against the
dishes. Refer to “Loading your machine”.
The door is difficult to close
■
The dishwasher is not level, or not
properly built-in.
Something not working
45
PSN08GB
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Force Centre, please carry out the
checks listed below.
The dishwasher is fitted with a number of alarm systems which can help you to quickly determine the
cause of any problems.
All indicator lights on the control panel are off (except the indicator light of the phase under way), the
machine stops and a fault code appears in the display.
- press the "Start" pushbutton to reset the alarm and restart the wash programme.
If the fault code reappears in the display, before contacting your local Service Force Centre, carry out
the following suggested corrective actions:
Summary of Contents for ZDS 679 EX
Page 28: ...0 05 98 ...
