1.
Check the filters
Ensure they are clean and properly
positioned (see cleaning instructions).
2.
Press the On/Off pushbutton
3.
Check that there is rinse aid
and salt
The indicator lights will flash if refilling is
necessary.
4.
Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the basket back into the machine.
5.
Ensure that the spray arms can
rotate freely.
6.
Measure out detergent
Add the required amount of detergent into
the dispenser according to the Programme
chart and close the detergent dispenser
lid.
7.
Close the dishwasher door
8.
Set the programme
Press the programme selector button until
the number corresponding to the required
programme appears in the display. The
indicator lights of the phases will remain on
until the programme starts.
The following options may also be
selected:
-
Half load by pressing the corresponding
button
-
Economy drying/No drying by pressing
the corresponding button.
-
Delay start by pressing the corresponding
button until the required number of hours
delay is setted.
9.
Press the start pushbutton
If a delay start has been selected, the
dishwasher starts the countdown and the
number of hours to go before the
programme starts appears in the display.
Once the delay set has elapsed, the
programme starts automatically.
When the programme starts all the
phases indicator lights turn off except the
phase under way.
If you wish to interrupt the wash
programme at any time, press the On/Off
pushbutton. To restart the machine, press
this pushbutton again and the wash
programme will resume at the point at
which it was interrupted.
10. At the end of the washing
programme
The dishwasher will automatically stop
and two zeros appear in the digital display.
All the indicator lights turn off.
Only the On/Off indicator light remains on.
Depress the On/Off button to switch the
dishwasher off.
Open the door.
11. Cancel the wash programme
To change or cancel a wash programme in
progress depress the start button until two
zeros appear in the digital display and the
indicator lights are off (except On/Off
indicator light). The previous setting has
been cancelled and a new programme can
now be selected.
When the wash programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working;if the
door is opened however, a safety device
ensures that the machine stops.
Caution
Do not open the door during the hot
phase: this may cause hot water
escape.
Care must be taken if the door is
opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
Operating sequence
42
POS09GB
Summary of Contents for ZDS 679 EX
Page 28: ...0 05 98 ...
