Error code
Possible cause
Remedy
EH0
The mains supply is unstable.
When the appliance is showing EH0,
please wait until main supply is stable
than press start. If the appliance
pause the cycle without any indication
then press the cycle start. If the warn-
ing will occur check the power cord /
socket integrity or main supply.
If the display shows other error codes, deactivate and activate the appliance. If the problem continues,
contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
TROUBLESHOOTING
Problem
Possible solution
You cannot activate the appliance.
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
The programme does not start.
Press
הלחתה
(Start/Pause).
Make sure that the appliance door is closed.
The appliance door does not close.
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
The appliance stops during operation.
Make sure that the water container is empty.
Press
הלחתה
(Start/Pause) to start the pro-
gramme again.
Load is too small, increase the load or use the
שוביי
יפל
ןמז
(Time Drying) programme.
The cycle time is too long or unsatisfactory dry-
ing result.
1)
Make sure that the weight of the laundry is appli-
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Ensure that the room temperature is higher than
+5°C and lower than +35°C. Optimal room tem-
perature is 18°C to 25°C.
Set the
שוביי
יפל
ןמז
(Time Drying) or the
ףסונ
(Extra Dry) programme.
2)
17
