20
CAUTION!
If the machine is connected to new pipes or pipes which have not been used for a long time, you
should run the water for a few minutes before connecting the inlet hose.
Ensure that the hoses
are not kinked, crushed
or entangled.
Drain hose
- Connect drain hose to the sink. Secure it with the
supplied hose clamp.
- Required height: 30 to 100 cm above bottom of
the dishwasher.
- If you use a drain hose extension the total length
should not be longer than 4 metres. Likewise the
internal diameter of the couplings used for
connections to the waste outlet must be no
smaller than the diameter of the hose provided.
WARNING!
●
Safety standards require the appliance to be
earthed. The manufacturer accepts no
liability for failure to observe the above
safety precautions.
●
Prior to using the appliance for the first time,
ensure that the rated voltage and type of
Electrical connection
supply on the rating plate match that of the
supply where the appliance is to be installed.
The fuse rating is also to be found on the
rating plate.
●
Always plug the mains plug into a correctly
installed shockproof socket.
Water inlet hose with safety valve
Connect the inlet hose to a water tap with an
external thread of 3/4”.
After connecting the double-walled water inlet hose,
the safety valve is next to the tap.
If the water inlet hose leaks, the safety valve cuts off
the water supply.
WARNING!
The electrical cable for the safety valve is in the
double-walled water inlet hose and is live.
Therefore do not immerse the water inlet hose or the
safety valve in water.
Take care when installing the water inlet hose.
Place the water inlet hose in such a way that it is
always lower than the bottom edge of the safety
valve.
If the water inlet hose or the safety valve is
danaged, remove the mains plug immediately.
ATTENTION!
A water inlet hose with safety valve MUST only be
replaced by your local Service Force Centre.
156998720en.qxp 1/31/2007 4:22 PM Page 20
