1. Press and hold Delay and XtraDry until the
indicators
,
,
and
flash and the display is blank.
As the appliance stores the saved settings, there is
no need to configure it before every cycle.
ADJUSTING THE WATER SOFTENER
Make sure the appliance is in user mode.
1. Press Program.
• The indicators
,
and are
off.
• The indicator
still flashes.
• The display shows the current setting: e.g.
= level 5.
2. Press Program to change the setting.
3. Press on/off button to confirm the setting.
If you use detergent or multi-tablets
containing salt and the hardness of
your water is lower than 21°dH, you
can set the lowest water softener level.
It deactivates the salt refill indicator. In
other cases, set the proper water
hardness level to keep the salt refill
indicator active.
THE WATER HARDNESS TABLE
German degrees
(°dH)
French degrees
(°fH)
mmol/l
Clarke degrees
Water softener
level
47 - 50
84 - 90
8.4 - 9.0
58 - 63
10
43 - 46
76 - 83
7.6 - 8.3
53 - 57
9
37 - 42
65 - 75
6.5 - 7.5
46 - 52
8
29 - 36
51 - 64
5.1 - 6.4
36 - 45
7
23 - 28
40 - 50
4.0 - 5.0
28 - 35
6
19 - 22
33 - 39
3.3 - 3.9
23 - 27
5
1)
15 - 18
26 - 32
2.6 - 3.2
18 - 22
4
11 - 14
19 - 25
1.9 - 2.5
13 - 17
3
4 - 10
7 - 18
0.7 - 1.8
5 - 12
2
<4
<7
<0.7
< 5
1
2)
1) Factory setting
2) Do not use salt at this level.
DEACTIVATING THE RINSE AID EMPTY
NOTIFICATION
Make sure the appliance is in user mode.
1. Press Option.
• The indicators
,
and are
off.
• The indicator
still flashes.
• The display shows the current setting:
–
= the rinse aid empty notification
is activated.
–
= the rinse aid empty notification
is deactivated.
2. Press Option to change the setting.
3. Press on/off button to confirm the setting.
If the drying results are satisfactory
while using multi-tablets only, it is
possible to deactivate the notification.
However, for best drying performance,
always use rinse aid.
ADJUSTING THE RINSE AID LEVEL
Make sure the appliance is in user mode.
1. Press Delay.
• The indicators
,
and
are off.
7
