Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not suf-
ficient. Adjust the rinse aid selector to a
higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase or
with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
activate the rinse aid dispenser and use
rinse aid together with the combi detergent
tablets.
Refer to ‘HINTS AND TIPS’ for other pos-
sible causes.
How to activate the rinse aid dispenser
1. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in
setting mode, refer to “Setting and starting
a programme”.
2. Press and hold, at the same time,
and
until the indicators of
,
and
start to flash.
3. Press
.
• The indicators of
and
go off.
• The indicator of
continues to
flash.
• The display shows the current setting.
Rinse aid dispenser off.
Rinse aid dispenser on.
4. Press
to change the setting.
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Technical information
Dimensions
Width / Height / Depth (mm)
600 / 850 / 625
Electrical connection
Refer to the rating plate.
Voltage
220-240 V
Frequency
50 Hz
Water supply pressure
Min. / max. (bar / MPa)
(0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
Capacity
Place settings
12
Power consumption
Left-on mode
0.99 W
Off-mode
0.10 W
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
2)
If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot
water supply to decrease energy consumption.
61
www.zanussi.com
Summary of Contents for ZDF14011WA
Page 75: ...75 www zanussi com ...
