Alarm code
Problem
• The start indicator flashes continuously.
• The end indicator flashes 3 times intermittently.
The anti-flood device is on.
Warning!
Deactivate the appliance before
you do the checks. Turn the programme
knob until the programme marker is aligned with
the on/off indicator.
Problem
Possible solution
You cannot activate the appliance.
Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
The programme does not start.
Make sure that the appliance door is closed.
Press the start button.
The appliance does not fill with water.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the water.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
Close the water tap and contact the Service.
After the checks are completed, turn the pro-
gramme knob until the programme marker is
aligned with programme that was in operation
when the problem occurred. The programme
continues from the point of interruption.
If the problem occurs again, contact the Serv-
ice.
If other alarm codes show, contact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a lower
position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses and
dishes
• The released quantity of rinse aid is not suffi-
cient. Adjust the rinse aid selector to a higher
position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase or
with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
Refer to ‘HINTS AND TIPS’ for other pos-
sible causes.
Technical information
Dimensions
Width / Height / Depth (mm)
600 / 850 / 625
34
www.zanussi.com
