A
A
B
Minimum distances
Dimension
mm
A
2
B
685
Levelling
Use small feet on the bottom of appliance to set same lev-
el of cooker top surface with other surfaces
The anti-tilt protection
Caution! You must install the anti-tilt protection (A
+B). If you do not install it the appliance can tilt.
Before you install anti-tilt protection, adjust the appliance
to the correct height.
The anti-tilt protection has two parts (A+B). You can find
the anti-tilt protection (B) on right or left side of the rear
wall of the appliance (See fig. 1). You must install the an-
ti-tilt protection (A) on the wall. The distance of the hole of
the anti-tilt protection (A) from the floor is about 816 mm.
Make sure you install the anti-tilt protection (A) at the cor-
rect height. Screw it into the solid material or use applica-
ble reinforcement.
Check that the anti-tilt protection projects minimum 20
mm into the hole in the back of the appliance (B) when
you push the appliance (See fig. 2). If the space between
the bench cupboards is greater than the width of the appli-
ance, you must adjust the side measurement to centre the
appliance. Make sure that the surface behind the appli-
ance is smooth.
2
1
B
60 mm
50 mm
A
Electrical installation
Warning! Only a qualified and competent person
must do the electrical installation.
The manufacturer is not responsible if you do not
follow safety precautions from the chapter "Safety
information".
This appliance is supplied without a main plug or a main
cable.
Covering terminal board
The recommended cross-section area is six square milli-
metres (6 mm²).
When you refit the mains terminal cover, make sure that
the lower tabs are located inside the bottom edge of the
aperture, before you fix the two screws into the top edge of
the mains terminal cover.
19
Summary of Contents for ZCV663
Page 1: ...EN User manual Cooker ZCV663 ...
Page 23: ...23 ...
