Zanussi ZCM900X, Instruction Booklet

Page: 21 / 28

21
Fig. 1
Fig. 2
TECHNICAL DATA
Table no.1
TABLE N°1: Adaption to various types of gas APPLIANCE CATEGORY:
II
2H3+
Burner Types of Gas Pressure Nozzle
Diameter
Rater Capacity Reduced
Capacity
by-pass Diameter
Mbar 1/100 mm. g/h l/h kw kcal/h kw Kcal/h 1/100 mm.
Natural G20 20 72 - 95 1 860 0,48 413 34
Auxiliary Butane G30 28 50 73 - 1 860 0,48 413 34
Propane G31 37 50 71 - 1 860 0,48 413 34
Semi- Natural G20 20 97 - 167 1,75 1505 0,6 516 36
rapid Butane G30 28 65 127 - 1,75 1505 0,6 516 36
Propane G31 37 66 125 - 1,75 1505 0,6 516 36
Natural G20 20 115 - 286 3 2580 1,05 903 52
Rapid Butane G30 28 85 218 - 3 2580 1,05 903 52
Propane G31 37 85 214 - 3 2580 1,05 903 52
Double Natural G20 20 135 - 334 3,5 3010 1,8 1548 65
Ring Butane G30 28 95 254 - 3,5 3010 1,8 1548 65
Propane G31 37 95 250 - 3,5 3010 1,8 1548 65
INSTALLATION
Positioning
Remove all the packaging and install the cooker
in a dry, ventilated room not near curtains,
paper, alcohol, petrol etc.
The appliance must be set on a heatproof, level
floor.
This appliance is approved to class “Y”
(EN60335-2-6 plus subsequent amendments).
This means that the appliance can be installed
up against a wall with a distance of not less than
20mm (fig 2) or inserted between 2 walls (fig 1).
Only one side wall can exceed the height of the
work surface and it must have a distance of
70mm from the edge of the cooker.
Any walls of the adjacent kitchen furniture and
the wall behind the cooker must be made with
heat resistant material that can withstand a
minimum overtemperature of 65K.
Any overhanging cabinetry installed above the
work surface must be located at a distance of no
less than 700mm.