Zanussi ZCG91016XA, User Manual

Page: 21 / 28

they do not come in touch with mobile parts and
they are not squeezed.
WARNING! When installation is
complete, make sure that the seal of
each pipe fitting does not leak. To
check the seal use a soap solution, not
a flame.
FLEXIBLE NONMETAL PIPES CONNECTION
If you have an easy access to the connection, you
can use a flexible pipe. The flexible pipe must be
tightly attached by clamps.
In installation always use the pipe holder and the
gasket. The flexible pipe can be applied when:
• it can not get hotter than room temperature,
higher than 30 °C,
• it is not longer than 1500 mm,
• it has no narrowing anywhere,
• it is not twisted or tighten,
• it does not get in touch with sharp edges or
corners,
• it's conditions can be easily checked.
When checking the flexible pipe make sure:
• it does not show cracks, cuts, marks of burnings
on the two ends and on its full length,
• the material is not hardened, but shows its
correct elasticity,
• the fastening clamps are not rusted,
• expired term is not due.
If one or more defects are visible, do not repair the
pipe, but replace it.
The gas supply ramp is on the rear side of the
control panel.
ADJUSTMENT TO DIFFERENT TYPES OF
GAS
WARNING! Let only an authorized
person do the adjustment to different
types of gas.
The appliance is set for liquid gas. You
can change it to natural gas, with the
correct injectors.
The gas rate is adjusted to suit.
WARNING! Before you replace the
injectors, make sure that the gas
knobs are in the Off position.
Disconnect the appliance from the
electrical supply. Let the appliance
cool down. There is a risk of injury.
The appliance is set to default gas. To
change the setting choose a pipe
holder from the list. Always use the
gasket sealing.
A C B
A. Gas connection end
B. Natural Gas pipe holder
C. LPG pipe holder
HOB INJECTORS REPLACEMENT
Replace the injectors when you change the gas
type.
1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
3. Remove the injectors with a socket spanner 7.
4. Replace injectors with the ones necessary for
the type of gas you use.
21