Zanussi ZCG55QG, User Manual

Page: 22 / 28

Supply piping should not be less than
R3/8. Connection is made to the Rc ½
(1/2 “ B.S.P.) female threaded. Entry pipe loca-
ted just below the hob level on the rear left
hand side of the appliance.
The gas supply ramp is on the rear side of the
appliance.
Warning! Only liquid sealants to be used
when inlet gas pipe is fitted i.e.: do not use
P.T.F.E. sealant tape.
When installation is complete. Carry out a gas
tightness test and make sure that the seal of
each pipe fitting is correct.
Important! Use flexible tubing, which comply
with BS.669 current edition.
A
B
C
C
D
E
Warning! The gas bayonet must be in
mark area.
Dimension mm
A 250
B 680
C 50
D 250
E 580
Pressure test
The Rapid injector is used as a pressure test
point.
1. Connect the pressure gauge to the Rapid
injector.
2. Examine the supply pressure by turning the
Rapid burner and one other burner fully on,
and lighting them. The pressure must be:
a) 20 mbar for Natural Gas
b) 29 mbar for LPG, butane only
c) 37 mbar for LPG, propane only.
3. Turn the taps off and disconnect the pres-
sure gauge.
4. Make sure that all burners work correctly.
Checking the grill
1. Put in the grill pan containing the grid.
2. Light the grill burner by turning the grill con-
trol knob to the symbol .
3. Release the knob when the burner comes
on.
Checking the hob burners
1. Lift the lid.
2. Put in the burner crowns and caps. Make
sure that they are correctly seated.
3. Put in the pan supports.
4. Check each of the burners in turn by turning
the burner control knob to the symbol .
5. Release the knob when the burners come
on.
Checking the main oven
1. Turn the gas oven control knob to the sym-
bol .
2. When the oven burner comes on, the gas at
first flows to the oven burner slowly, at the
FSD by-pass rate.
3. When the FSD heat sensor is heated suffi-
ciently, it opens the FSD valve. The main
gas stream flows to the burner.
4. After 1 minute make sure that the flame
covers the full width of the burner and is
stable.
5. Set the oven control knob to the maximum
position and close the oven door. After
22
www.zanussi.com