Zanussi ZCG550, User Manual

Page: 9 / 28

Replacing burner parts
1. Carefully put the burner crown on the burn-
er body. Do not use force.
a) Make sure that the hole in the crown is
above the ignition candle.
b) Make sure that the location pegs are in
the slots in the burner body.
c) Let the crown fall freely onto the body.
d) Make sure that you can move the
crown a small distance from side to
side.
2. Put the burner cap centrally on top of the
crown (enamel side up). Move the cap from
side to side and front to back to make sure
that it is correctly installed.
3. Try to light the burner. If the burner does
not ignite, adjust the crown and cap again.
Warning! Do not keep the control knob
pushed for more than 15 seconds.
If the burner does not light after 15 seconds,
release the control knob, turn it into off position
and try to light the burner again after minimum 1
minute.
If the burner accidentally goes out, turn the
control knob to the off position and try to
light the burner again after minimum 1 minute.
The spark generator can start automatically
when you switch on the mains, after instal-
lation or a power cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the sym-
bol
.
Warning! Always turn the flame down or
switch it off before you remove the pans
from the burner.
Hob - Helpful hints and tips
Warning! Refer to the Safety chapters.
Energy savings
• If possible, always put the lids on the pans.
• When the liquid starts to boil, turn down the
flame to barely simmer the liquid.
Use pots and pans with diameter applica-
ble to the dimension of burner.
Burner Diameters of cookware
Rapid 180 mm - 260 mm
Semi-rapid 120 mm - 220 mm
Auxiliary 80 mm - 160 mm
Use cookware with the bottom as thick and flat
as possible.
Hob - Care and cleaning
Warning! Refer to the Safety chapters.
Warning! Switch the appliance off and let
it cool down before you clean it.
Warning! For safety reasons, do not clean
the appliance with steam cleaners or high-
pressure cleaners.
Warning! Do not use abrasive cleaners,
steel wool pads or acids, they can cause
damage to the appliance.
• To clean the enamelled parts, cap and crown,
wash it with warm soapy water.
• Stainless steel parts wash with water, and
then dry with a soft cloth.
• The pan supports are not dishwasher proof;
they must be washed by hand .
• Make sure you position the pan supports cor-
rectly after cleaning.
• To make burners work correctly, make sure
that the arms of the pan supports are in the
centre of the burner.
• Be very careful when you replace the
pan supports to prevent the hob top
from damage.
9
www.zanussi.com