22
Electrical connection
Important
In any connection way the appliance
has to be grounded, in accordance with
the national rules in force. We decline
any responsibility in case of accidents
due to no grounding or wrong
grounding.
Fuse capacity: 16A
Note:
Check on the rating plate the value for the
total connection power for establishing the
fuse power.
The supply cord must be positioned in such
a way as it does not reach in any point a
temperature higher by 50ºC than the room
temperature.
Before connecting check that:
•
fuse and household electric installation
can bear the charge of the appliance
(see rating plate);
•
The socket or the omnipolar switch used
for connection is easily reachable when
the appliance is installed.
How to proceed?
•
Unscrew and remove the protective
cover at the back of the appliance;
•
Connect the power cord to the terminal
of the cooker according to the table
no.1;
•
Fix by means of cable clamp;
•
Make sure that the connection to the
terminal is matching the network power;
•
Remount and screw the protective cover
at the back of the appliance.
Important
If the supply cord is damaged it
must be replaced by the manufacturer or
its service agent or a similarly qualified
person in order to avoid a hazard.
OVEN LAMP REPLACEMENT
Before replacing the lamp take care
that all control knobs be on “off”
position
« ».
Disconnect the appliance; watch that the
oven be cool.
This lamp of 15 W, convection E 14
(230/240V)
is a special
lamp for “higher”
temperature
, up to 300
˚
C. It is
supplied on
order, by your After Sales Service.
The lamp is fixed in back of the oven and is
accessible from inside.
For reaching the lamp:
1. Unscrew the glass lamp protection
(fig.16);
2. Unscrew the lamp;
3. Replace the lamp;
4. Remount the lamp protection
During use the appliance becomes
hot. Care should be taken to avoid
touching heating elements inside the
oven.
fig.16
