As the colours of the wires in the mains lead of this appli-
ance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
1. Connect the wire coloured green and yellow to the
terminal marked either with the letter “E“ or by the
earth symbol or coloured green and yellow.
2. Connect the wire coloured blue to the terminal either
marked with the letter “N“ or coloured black.
3. Connect the wire coloured brown to the terminal ei-
ther marked with the “L“ or coloured red.
4. Check that no cut, or stray strands of wire is present
and the cord clamp
4
is secure over the outer
sheath.
5. Make sure the electricity supply voltage is the same
as that indicated on the appliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted
2
.
In the event of having to change the fuse in the plug sup-
plied, a 13 amp ASTA approved (BS 1362) fuse must be
used.
Warning! A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard. Ensure
that it is disposed of safely.
Removing the shelf holders
Your appliance is equipped with shelf retainers to secure
the shelves during transportation.
To remove them proceed
as follows:
1. Rise the shelf from
the back (A).
2. Push it in the direc-
tion of the arrow until
it is free (B).
3. Remove the retainers
(C).
A
B
Door reversibility
The door of the appliance opens to the right. If you want to
open the door to the left, do these steps before you install
the appliance:
• Loosen the upper pin
and remove the spacer.
• Remove the upper pin
and the upper door.
S
• Loosen the middle
hinge.
• Remove the lower door.
• Loosen the lower pin.
On the opposite side:
• Install the lower pin.
• Install the lower door.
• Tighten the middle
hinge.
• Install the upper door.
• Tighten the spacer and
tighten the upper pin.
12
