Problem
Possible cause
Solution
The product temperature is too
high.
Let the product temperature de-
crease to room temperature before
storage.
The room temperature is too high.
Decrease the room temperature.
Water flows on the rear
plate of the refrigerator.
During the automatic defrosting
process, frost defrosts on the rear
plate.
This is correct.
Water flows into the re-
frigerator.
The water outlet is clogged.
Clean the water outlet.
Products prevent that water flows
into the water collector.
Make sure that products do not
touch the rear plate.
Water flows on the
ground.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
Attach the melting water outlet to
the evaporative tray.
The temperature in the ap-
pliance is too low.
The temperature regulator is not
set correctly.
Set a higher temperature.
The temperature in the ap-
pliance is too high.
The temperature regulator is not
set correctly.
Set a lower temperature.
Replacing the bulb
If you want to replace the bulb, do these steps:
1.
Break the circuit of the appliance.
2.
Unscrew the lamp cover securing screw.
3.
Unhook the moving part by pressing it as
shown in the figure.
4.
Replace the bulb with one of the same
power and specifically designed for
household appliances (the maximum pow-
er is shown on the light bulb cover).
5.
Fix the lamp cover in place.
6.
Screw the lamp cover securing screw.
7.
Reconnect the appliance.
8.
Open the door and check if the light
comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "In-
stallation".
3.
If necessary, replace the defective door
gaskets. Contact the Service Center.
19
www.zanussi.com
Summary of Contents for ZBA14441SC
Page 53: ...53 www zanussi com ...
Page 54: ...54 www zanussi com ...
Page 55: ...55 www zanussi com ...
