2.
Remove any stored food, wrap it in several
layers of newspaper and put it in a cool
place.
3.
Leave the door open.
4.
When defrosting is completed, dry the in-
terior thoroughly and refit the plug.
5.
Switch on the appliance.
6.
Set the temperature regulator to obtain the
maximum coldness and run the appliance
for two or three hours using this setting.
7.
Reload the previously removed food into
the compartment.
Important!
Never use sharp metal tools to
scrape off frost from the evaporator as you
could damage it. Do not use a mechanical
device or any artificial means to speed up the
thawing process other than those
recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long peri-
ods, take the following precautions:
•
disconnect the appliance from electric-
ity supply
• remove all food
• defrost (if foreseen) and clean the appliance
and all accessories
• leave the door/doors ajar to prevent un-
pleasant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food in-
side from spoiling in case of a power failure.
What to do if…
Warning!
Before troubleshooting,
disconnect the mains plug from the mains
socket.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Important!
There are some sounds during
normal use (compressor, refrigerant
circulation).
Problem
Possible cause
Solution
The appliance does not
operate. The lamp does
not operate.
The appliance is switched off.
Switch on the appliance.
The mains plug is not connected to
the mains socket correctly.
Connect the mains plug to the mains
socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
The lamp does not work.
The lamp is in stand-by.
Close and open the door.
The lamp is defective.
Refer to "Replacing the lamp".
The compressor operates
continually.
The temperature is not set correct-
ly.
Set a higher temperature.
The door is not closed correctly.
Refer to "Closing the door".
The door has been opened too fre-
quently.
Do not keep the door open longer
than necessary.
18
www.zanussi.com
Summary of Contents for ZBA14441SC
Page 53: ...53 www zanussi com ...
Page 54: ...54 www zanussi com ...
Page 55: ...55 www zanussi com ...
