34
MAINTENANCE
Clean the control panel with a damp cloth, do not use
abrasive products. The knobs can be removed by lif-
ting to facilitate cleaning.
The enamelled part of the hob can be cleaned with
warm water and detergent.
Although the enamel will tollerate acids, we advise
you to quickly remove splashes of vinigar, lemon and
all acid substances.
Also immediately remove all residue of fat or other to
avoid any incrustation. If incrustations have formed
leave the crust immersed in hot water. Never use
metal brushes, knives or similar objects which could
scratch the enamel. Avoid using acid detergents.
Clean steel hobs with specific detergents.
To ensure the long-life of the hob, we advise you to
clean it regularly. Naturally, before cleaning the
plates, allow them to cool.
Do not acquire the bad habit of wiping over the plates
with a damp cloth whilst they are still hot. Although
they will.
stand up to such teatment, fragments of the cloth
could remain. The plates and their bases can,
however, be cleaned occasionally using fine
sandpaper.
The base of the plates in special steel will stay
impeccable if cleaned with hot water and vinigar. We
advise you to grease the surface of the plates from
time to time with a non-acid fat (cooking oil, sewing
machine oil or vaseline). Products for care and
maintenance are available commercially.
INSTRUCTIONS FOR INSTALLATION
INSTALLATION
The appliance is of type X and has been designed to
be built into or fitted next to units according to the
regulations in force (IEC 61-80).
The side walls of the unit must not exceed the height
of the appliance’s hob.
Avoid installing the appliance in the proximity of
inflammable materials (e.g. curtains, tea towels, etc.).
ELECTRICAL CONNECTION
The appliance is predisposed to function with a 220/
230 V monophase voltage tension.
The connection must be carried out in conformity
with the regulations and dispositions of the laws in
force.
Before connecting ensure that:
-
the limiter valve and the electrical mains can
support the voltage of the appliance (see label).
-
the power supply is correctly earthed according to
the regulations in force.
-
the plug or omnipolar interrupter used can be
easily reached once the appliance has been
installed.
Fit a sectioned plug to the voltage cable and connect
to a security socket.
If a direct connection to the mains is required an
omnipolar interrupter with a minimum opening of 3
mm between contacts which does not interrupt the
neutral, corresponding to regulations in force, should
be interposed between the appliance and the supply.
The brown coloured phase cable (situated at terminal
“L” of the terminal box) must always be connected to
the network phase.
The voltage cable must always be positioned in such
a manner that it at no point reaches a temperature of
80
°
C above room temperature.
