![background image](http://html.mh-extra.com/html/zanussi/z712w43bi/z712w43bi_user-manual_925131037.webp)
Problem
Possible solution
The programme dura-
tion increases or de-
creases during pro-
gramme execution.
• The AutoAdjust System is able to adjust the programme duration ac-
cording to the type and the laundry load size. Refer to "The AutoAdjust
System load detection" in "Daily Use" chapter.
The washing results are
not satisfactory.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before you wash
the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
Too much foam in the
drum during the wash-
ing cycle.
• Reduce the quantity of detergent.
After the washing cycle,
there are some deter-
gent residues in the dis-
penser drawer.
• Make sure that the flap is in the correct position (UP for powder deter-
gent - DOWN for liquid detergent).
• Make sure you have used the detergent dispenser according the indi-
cations given in this user manual.
After the check, activate the appliance. The programme continues from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
EMERGENCY DOOR OPENING
In case of power failure or functioning failure the
appliance door remains locked. The washing
programme continues when the power is restored.
If the door remains locked in case of failure, it is
possible to open it using the emergency unlock
function.
Before opening the door:
CAUTION! Risk of burns! Make
sure that the water temperature is
not too high and the laundry is
not hot. If necessary, wait until
they cool down.
CAUTION! Risk of injury! Make
sure that the drum is not rotating.
If necessary, wait until the drum
stops rotating.
Make sure that the water level
inside the drum is not too high. If
necessary, proceed with an
emergency drain (refer to
«Emergency drain» in «Care and
cleaning» chapter).
To open the door, proceed as follows:
1. Press the On/Off button to switch the
appliance off.
2. Disconnect the mains plug from the mains
socket.
3. Pull the emergency unlock trigger downward
once. Pull it once again, keep it tensed and, in
the meanwhile, open the appliance door. The
emergency unlock trigger is located where
indicated by the following picture.
4. Take out the laundry and then close the
appliance door.
37
Summary of Contents for Z712W43BI
Page 1: ...GETTING STARTED EASY User Manual Z712W43BI EN User Manual Washing Machine ...
Page 41: ......
Page 42: ......
Page 43: ......