35
FEEDER CABLE SECTION TYPE
HO5RR-F
230 V
3 x 0,75 mm
2
230 V
PE
N
L
1
(L
2
)
Fig. 9.2
ELECTRICAL FEEDER CABLE
CONNECTION
To connect the supply cable:
- Remove the screws securing the
cover “A” on the rear of the cooker
(fig. 9.1).
- Feed the supply cable through the
cable clamp “D”. The supply cable
must be of a suitable size for the cur-
rent requirements of the appliance;
see the section “Feeder cable sec-
tion” (fig. 9.1).
- Connect the wires to the terminal
block “B” as shown in the diagram in
figure 9.2; or connect the phase wires
to the terminal block “B” and the earth
wire to the terminal PE (fig. 9.1) as
shown in figure 9.2.
- Take up any slack in the cable and
secure with the cable clamp “D”.
- Replace the cover “A”.
Fig. 9.1
D
B
PE
A
;;;
;;;
;
;
;
;
;
;
;
;
;
;;
Switches igniter and electrodes can be
replaced after lifting the cooktop, follow-
ing the instructions shown in the chapter
‘REPLACEMENT OF THE TOP INJEC-
TORS”
REMPLACEMENT OF ELECTRICAL
COMPONENTS SITUATED UNDER
THE COOKTOP
Before effecting any intervention on
the electrical parts of the appliance,
the connection to the network must
be interrupted.
