26
INSTALLATION
If this model, equipped with a magnetic door lock,
replaces an old appliance with a catch, ensure that the
latter cannot be used before discarding it to prevent
children being trapped inside.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature b18
°
C and +43
°
C (class T);
+18
°
C and +38
°
C (class ST); +16
°
C and +32
°
C (class
N); +10
°
C and +32
°
C (class SN).
The class of your appliance is shown on its rating plate.
Ensure that air can circulate freely around the back,
top and bottom of the cabinet.
If the appliance is positioned below an overhanging
kitchen unit, the minimum distance between the top
of the cabinet and the wall unit must be at least
100 mm (Fig. - A).
The ideal solution, however, is the one shown in
Fig. - B (without an overhanging unit).
The appliance can be installed with its sides
touching adjacent kitchen units provided that air
can circulate freely around the back and top.
Accurate levelling is ensured by one or more
adjustable feet at the base of the refrigerator.
NP008
A
B
100 mm
10 mm
10 mm
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by
±
6% of the rated value.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. directive
no. 87/308 of 2/6/87 concerning the suppression of
radio interference.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic Compatibility
Directive) and subsequent modifications.
Cleaning
Before using, clean all inside parts with warm water
and neutral detergent to remove the typical new
smell. Dry thoroughly.
Do not use abrasive powders as these can damage
the finish.
GB