40
The tumble dryer must be installed in a clean place,
where dirt does not build up.
Make sure there are no
obstructing items or
material near the air-in-
take louvres provided at
the back (e.g. paper,
rags etc.).
Important
When operating the tumble dryer, the room tempera-
ture must not exceed 35°C, as it may affect the perfor-
mance of the appliance.
To save energy, the room temperature should not be
lower than +15°C.
Levelling
Level the tumble dryer
into place by screwing or
unscrewing the front feet
as required.
Accurate levelling will
keep vibration and
noise to a minimum
when the dryer is in
use.
Electrical connection
This machine is designed to operate on a 220-230 V,
single-phase, 50 Hz supply.
Check that your domestic electrical installation can
take the maximum load required (2.2 kW), also taking
into account any other appliances in use.
Connect the machine to an earthed socket, in accor-
dance with current wiring regulations.
The manufacturer declines any responsibility for
damage or injury through failure to comply with
the above safety precaution.
Door reversal
To make it easier to load or unload the laundry the
door can be reversed.
This operation must be carried out by qualified
personnel.
Operate as follows:
- Remove the door by unscrewing the two screws (1)
fastening the hinge to the cabinet (Fig. A).
- Remove the catch (2) by pressing it down (fig. A)
and refit it on the opposite side. When the door is
refitted, it will be at the top (fig. B).
- Remove the screws (3), the plastic plate (4) and (5)
with a screwdriver, taking care not to damage the
cabinet (fig. A).
Refit the parts on the opposite side (fig. B).
- Refit the door by screwing in the two screws (1)
which fasten the door to the cabinet (Fig. B).
P0281
P0046
1
2
3
4
P0883
5
A
1
2
3
4
P0884
5
B
Summary of Contents for TDS360T
Page 10: ...125996211 ETEOS ...
