Zanussi FJS 1386, Instruction Booklet

Page: 7 / 20

7
ENGLISH
Water inlet
The inlets on the back of the appliance are
colour coded, blue for cold and red for hot.
Before connecting the hoses be sure to fit the
mesh filters «A» supplied as per diagram.
If only a cold water supply is available, connect
the two hoses to a cold water outlet by means of
a «Y» connection piece.
Installation should comply with local water
authority and building regulations’ requirements.
The appliance must be given a separate cold
water supply and not be connected to a mixer
tap, a single outlet water heater or a booster
pump. A minimum water pressure of 0.48 bar is
required for safe operation of the appliance.
Set the hoses correctly by loosening the ring
nuts. After positioning the inlet hoses, be sure to
tighten the ring nuts again to prevent leaks.
Water drainage
The end of the drain hose can be positioned in
three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the machine is
emptying.
This could be done by tying it to the tap with a
piece of string or attaching it to the wall.
In a sink drain pipe branch. This branch must
be above the trap so that the bend is at least
60 cm above the ground.
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter of
the drain hose.
The drain hose must not be kinked. Run it along
the floor; only the part near the drainage point
must be raised.
Electrical connection
This machine is designed to operate on a 220-
240 V, single-phase, 50 Hz supply.
Check that your domestic electrical installation
can take the maximum load required (2 kW),
also taking into account any other appliances in
use.
Connect the machine to an earthed socket.
A
P0003
P0022
P0023
P0021
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the above
safety precaution.
The electrical cable must be replaced
only by an authorized service centre.