- 15 -
Installation
Levelling the machine
The machine must be installed on a sound and firm
surface and must not be touching walls or furniture.
Adjust the feet to level the machine. Make sure the
machine is resting on all four feet (Fig. 1).
Some vibration is normal and unavoidable when
the machine is spinning the load, particularly if
the floor is not a concrete one.
When the appliance location is on carpet
floors, attention must be paid so as to ensure
that there is no obstruction to the bottom vents.
Water inlet
Connect the inlet hose to a tap with a 3/4" pipe
thread. If necessary, use the restrictor (1/2”)
supplied (Fig. 2).
The inlet hose must not be joined onto any form
of extension hose. If it is too short, the entire hose
must be replaced with a longer high-pressure hose,
specially designed for the purpose.
The machine end of this hose can be turned in any
direction. Loosen the retaining nut, turn the hose,
then retighten the nut (Fig. 3).
Check that the nut is tightend before the
machine is moved into position.
Use only the inlet hose supplied with the
machine, do not reuse the old inlet hose.
3
2
1
Summary of Contents for FCS 720C
Page 17: ......
