1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Press the On/Off push button
The On/Off indicator light will come on (setting mode).
5. Setting and starting the programme
Press the push button corresponding to the required
programme (see "Washing programmes" chart).
The indicator light corresponding to the programme and
the phase indicator lights foreseen for that
programme will start blinking.
After about 3 seconds from the last pressure of a push
button the programme starts automatically.
Once the programme has started the phase indicator lights
will turn off except for the phase under way.
Note: it is possible to select a washing programme also
with the door slightly opened.
In this case the start of the programme will occur after the
closure of the door. Until this moment it is possible to
modify the setting made.
a) Press On/Off push button.
b) Select a washing programme.
c) Close the door.
The programme or the countdown will start automatically
after about 3 seconds from the closure of the door.
6. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme in
progress
a) Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
b) Press the On/Off push button (in this case all the
indicator lights turn off). Press the On/Off push button
again; the programme will start from the point in which it
was interrupted.
To cancel a washing programme in
progress
To cancel a washing programme in progress, press
simultaneously the function push buttons 2 and 3 until all
the indicator lights will turn off (except for the On/Off
indicator light and eventually the rinse aid and salt
indicator lights) indicating that the running programme has
been cancelled.
(If a new washing programme will be selected, check that
there is detergent in the detergent dispenser).
7. End of the washing programme
The dishwasher will automatically stop and the End of
cycle phase indicator light will illuminate.
The indicator light of the programme just ended will
remain on.
Switch off the dishwasher by pressing the On/Off push
button, the On/Off indicator light turns off.
Open the door and wait a few minutes before removing
the dishes; in this way they will be cooler and the drying
will be improved.
8. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Starting a washing programme
13
