Starting the programme
1. Scrape or rinse off solid food remnants.
2. Load the dishwasher.
(See the basket and loading).
3. Put the correct amount of detergent into the
detergent dispenser and close the dispenser lid.
4. Close the door.
5. Select the required programme (see pro gramme
chart). The programme indicator lamps starts to
flash.
6. Press in the start button. The lamp for the start
button comes on and dishwashing cycle starts.
The programme indicator lamps always indicates
which part of the selected cycle the dishwasher
is in.
7. Check the filters to see if they need to be
cleaned when the dishwasher has finished
the programme.
Interrupting the programme temporarily
1. Open the door. The programme stops.
2. Close the door and the programme continues
after about six seconds.
Open the door carefully when the dishwasher
is running, since hot steam may escape.
Cancelling the programme
1. Press and hold in the start button until the
programme indicator lamps goes out.
2. Release the button, the programme indicator
lamps starts to flash.
3. Turn the programme selector to the ”Reset”
position. The programme is now cancelled and
a new programme can be selected.
If you simply turn the programme selector to the
”Reset” position, the selected programme is not
finished, it is only disrupted. The programme will
continue if you turn the programme selector to
the programme again.
Cancelling the drying phase
In case you do not want to wait until the drying phase is
completed, you can cancel it.
1. Press and hold in the start button until the
programme indicator lamps starts to flash,
then release the button.
2. Open the door. The drying phase is cancelled.
Switching the dishwasher off
Switch the dishwasher off, when the indicator lamp
for the programme cycle end is lit.
1. Turn the programme selector to the ”Reset”
position. All indicator lamps goes out.
Leave the door slightly ajar.
Be careful if you open the door immediately
after the programme is finished, since hot
steam may escape.
- 10 -
Using the appliance
