Zanussi Electrolux W1206, Instruction Booklet

Page: 13 / 29

ENGLISH
11 SKIP/RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the machine on, the blinking zero will reappear.
You can also press the SKIP/RESET button to
exclude one or several phases of the programme
which is running, as indicated below.
- set the machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the SKIP/RESET button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the name of the phase(s) will go
out).
Example:
In this case, both the
drain and the spin (at the
speed provided for the
selected type of fabric)
will be performed.
This button allows you also to select special
programmes , such as RINSES , SPIN and DRAIN .
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress SKIP/RESET once or repeatidly to cancel
the previously performed programme;
- select the type of fabric by means of FABRICS
button;
- select the special programme:
• RINSES
Depress SKIP/RESET once , the pilot light WASH
goes out.
• SPIN
Depress SKIP/RESET twice , the pilot lights WASH
and RINSES go out.
Prewash
Wash
Rinse
Spin
Dry
Drain
• DRAIN
Depress SKIP/RESET three times , the pilot lights
WASH , RINSES and SPIN go out, and only the
pilot light DRAIN will light on .
Example:
In this case the machine
will perform the rinses
followed by the spin.
12 DELAY START button
This button makes it possible to delay the starting of
the programme selected from 30 min - 60 min - 90
min, 2 hours and then by 1 hour up to a maximum of
23 hours. The delay you have selected is shown on
the display for about 3 seconds; afterwards, the
duration of the programme reappears.
You must select this option after you have set the
programme and before you press the
START/PAUSE button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to
cancel the delay time,
proceed as follows:
• set the washing machine to PAUSE by pressing the
START/PAUSE button;
• press the DELAY button twice, to erase the delay
time. The display will indicate « 0’ ».
• press the START/PAUSE button again.
Important!
The door will be locked throughout the delay time.
If you need to open the door, you must first set the
machine to PAUSE by pressing the START/PAUSE
button. After you have closed the door, press the
START/PAUSE button again.
13