• Make sure that the rated voltage and type of power
on the rating plate agree with the voltage and the
power of the local power supply.
• This appliance is supplied with a mains cable. It has
to be supplied with a correct plug, able to support the
load marked on the rating plate. The plug has to be
fitted in a correct socket.
• Any electrical component must be installed or re-
placed by the Service Force Centre technician or
qualified service personnel.
• Always use a correctly installed shockproof socket.
• Make sure that there is an access to the mains plug
after installation.
• Do not pull the mains cable to disconnect the appli-
ance. Always pull the mains plug.
• The appliance must not be connected with an exten-
sion cable, an adapter or a multiple connection (risk
of fire). Check that the ground connection is in con-
formity with the standard and regulations force.
• The power cable must be placed in such a way that
it does not touch any hot part.
• Connect the appliance to the mains with a device
that lets to disconnect the appliance from the mains
at all poles with a contact opening width of minimum
3 mm, eg. automatic line protecting cut-out, earth
leakage trips or fuse.
• None of a parts of the connection cable can not get a
temperature 90 °C. The blue neutral cable must be
connected to the terminal block label with "N". The
brown (or black) phase cable (fitted in the terminal
block contact marked with "L") must always be con-
nected to the live phase.
Replacement of the connection cable
To replace the connection cable use only H05V2V2-F
T90 or equivalent type. Make sure that the cable sec-
tion is applicable to the voltage and the working tem-
perature. The yellow/green earth wire must be approxi-
mately 2 cm longer than the brown (or black) phase
wire.
Assembly
40-50 mm
55 mm
30 mm
min. 650 mm
490 mm
min. 100 mm
270 mm
If several 30 cm hobs are to be installed side by side
into the same cut out, an assembly kit including a sup-
port side bracket and supplementary seals is available
at our Service Centres. The relevant installation instruc-
tions are supplied within the kit package.
B
A
A — seal to remove
B — supplied brackets
Caution!
Install the appliance only on a worktop
with flat surface.
Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must be easy to re-
move and let an easy access in case a technical assis-
tance intervention is necessary.
min 20 mm
(max 150 mm)
30 mm
60 mm
B
A
a) Removable panel
b) Space for connections
17
Summary of Contents for ZKE320
Page 39: ...39...