When the container is full of water, put the drainage
duct back again and empty the container. Do steps 3
and 4 again and again until no more water flows out
from the drain pump.
1
2
Pull back the drainage duct.
Unscrew the filter and remove it.
Remove fluff and objects from the pump.
Make sure that the impeller of the pump can turn. If
this does not occur, contact the service centre.
2
1
Clean the filter under the water tap and put it back in
the pump into the special guides.
Make sure that you tighten correctly the filter to pre-
vent leakages.
Close the pump door.
Caution!
When the appliance is in use and
depending on the programme selected there can
be hot water in the pump.
Never remove the pump cover during a wash cycle,
always wait until the appliance has finished the cycle,
and is empty. When refitting the pump cover, ensure it
is securely re-tightened so as to stop leaks and young
children being able to remove it.
Cleaning the water inlet filters
Important!
If the appliance doesn't fill, takes long to fill
with water, the starting button blinks yellow or the
display (if available) shows the relevant alarm (see
chapter "What to do if..." for more details), check if the
water inlet filters are blocked .
To clean the water inlet filters:
21
