HIGH SPEED
N
.B. Do not insert plastic detergent containers in the drum as they may overheat
and possibly melt (Fig. 31).
Only use the soap powder container fitted on the machine.
1) Press the half-load pushbutton (Fig. 27).
- Press the spin speed selector (Fig. 28) according to the type of fabric*.
- Do not press the rinse stop pushbutton (Fig. 29) or the no-spin pushbutton (Fig. 30).
- Set the drying time with timer knob (M)***., according to the type of fabrics*.
- Select the most suitable programme and the correct temperature with programmer
(P) and thermostat knobs (T)*.
- Set the programme on programmer knob (P) (Fig. 32) and temperature on the
adjustable thermostat if fitted.
- To start the machine, pull programmer knob (P) (Fig. 32), or if the machine is
fitted with pushbuttons, press the start pushbutton (Fig. 35). This indicator light
will be illuminated (Fig. 36).
2) At the end of the washing and drying programme, the machine will stop on one
of the STOP positions on the programmer (Fig. 33).
3) The timer knob (M) stops in the position "O".
4) Press the programmer knob (P) (Fig. 32), or press and release the stop pushbutton
(if fitted) (Fig. 35).
5) Remove the washing.
6) With dry hands, disconnect the washing machine from the electricity supply (Fig. 34).
7) Turn off the water tap (Fig. 38).
N
.B. Before starting the drier, remove any detergent containers from the inside the
drum (Fig. 31).
Warning! Do not dry garments treated with solvents or petroleum based products,
as these volatile substances may cause an explosion.
N.B. Be careful not to overdry the clothing: excessive drying could crease the items
and make them difficult to iron. Do not use the machine for drying sleeping bags,
eiderdowns, pillows or bulky blankets, as these articles expand while drying and may
prevent the hot air from circulating in the machine. When the programmer knob (Fig.
32) is in the stop position, the drying function can be selected.
1) Load the machine and close the door, remembering that the best drying results
are obtained by not exceeding the loads indicated***.
2) Set the drying time with the knob (M).
3) Position programmer (P) (Fig. 32) on STOP for resistant fabrics or on STOP for
delicate fabrics (Fig. 33).
4) Warning! Turn on the water supply tap and leave it open during the program
cycle (Fig. 37).
5) Ensure that the discharge hose is positioned correctly.
6) With dry hands, connect the machine to the electrical supply (Fig. 34).
8
Using
the machine
as a dryer
Fig.27
Fig.28
Continuous
wash/dry
cycle
Fig.30
Fig.29
* See "Use of the machine" paragraph 15 (page 7)
** See Table of drying times and weights (page 12)
Fig.34
Fig.32
Fig.33
Fig.31
