ZANKER PVX1556, User Manual

Page: 8 / 40

The rinse aid is automatically released during the hot
rinse phase.
When rinse aid chamber is empty, the rinse aid indicator
is turned on notifying to refill rinse aid. If the drying
results are satisfactory while using multi-tablets only, it
is possible to deactivate the notification for refilling rinse
aid. However, for best drying performance, always use
rinse aid.
If standard detergent or multi-tablets without rinse aid
are used, activate the notification to keep the rinse aid
refill indicator active.
How to deactivate the rinse aid empty notification
Make sure the appliance is in user mode.
1. Press .
• The indicators , , and are
off.
• The indicator still flashes.
• The indicator shows the current setting.
– If the indicator is on = the rinse aid
empty notification is activated.
– If the indicator is off = the rinse aid
empty notification is deactivated.
2. Press to change the setting.
3. Press on/off to confirm and save the setting.
The rinse aid level
It is possible to set the released quantity of rinse aid
between level 1 (minimum quantity) and level 6
(maximum quantity). Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press .
• The indicators , , and are
off.
• The indicator still flashes.
• The indicator starts flashing. The number
of flashes indicates the current setting: e.g. 4
f pause + 4 flashes... = level 4.
– The levels of rinse aid range from 0 to 6.
– Level 0 means no rinse aid is used. In this
case the indicator remains off.
2. Press
repeatedly to change the setting. Each
pressing of increases the level number. After
reaching level 6, the count starts again from level 1.
3. Press on/off to confirm the setting.
Acoustic signals
Acoustic signals sound when a malfunction of the
appliance occurs. It is not possible to deactivate these
acoustic signals.
There is also an acoustic signal that sounds when the
programme is completed. By default this acoustic signal
is deactivated but it is possible to activate it.
How to activate the acoustic signal for the end of
programme
Make sure the appliance is in user mode.
1. Press
• The indicators , , and are
off.
• The indicator still flashes.
• The indicator shows the current setting.
– If the indicator is on = the acoustic
signal is activated.
– If the indicator is off = the acoustic
signal is deactivated.
2. Press to change the setting.
3. Press on/off to confirm the setting.
AirDry
AirDry improves the drying results with less energy
consumption.
During the drying phase, the door opens
automatically and remains ajar.
8