ZANKER KUAK88ES, User Manual

Page: 12 / 32

Problem Possible cause Solution
Temperature set in the appliance is
too low and the ambient tempera-
ture is too high. Set a higher temperature. Refer to
"Control Panel" chapter.
Water flows on the floor. The melting water outlet is not con-
nected to the evaporative tray
above the compressor. Attach the melting water outlet to
the evaporative tray.
Temperature cannot be set. The "Super function" is switched on. Switch off "Super function" manual-
ly, or wait until the function deacti-
vates automatically to set the tem-
perature. Refer to "Super function"
section.
The temperature in the appliance is
too low/too high. The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door" section.
The food products' temperature is
too high. Let the food products temperature
decrease to room temperature be-
fore storage.
Many food products are stored at
the same time. Store less food products at the
same time.
The thickness of the frost is greater
than 4-5 mm. Defrost the appliance.
The door has been opened often. Open the door only if necessary.
The Super function is switched on. Refer to "Super function" section.
There is no cold air circulation in the
appliance. Make sure that there is cold air cir-
culation in the appliance. Refer to
"Hints and Tips" chapter.
Power indicator light flashes. An error has occurred in measuring
the temperature. Contact a qualified electrician or the
nearest Authorized Service Centre.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to installation
instructions.
3. If necessary, replace the defective door gaskets.
Contact the Authorised Service Centre.
12