ZANKER KIT8470XXK, User Manual

Page: 13 / 32

Problem Possible cause Remedy
You do not set the heat setting for
10 seconds. Activate the hob again and set the
heat setting in less than 10 sec-
onds.
You touched 2 or more sensor fields
at the same time. Touch only one sensor field.
Pause operates. Refer to "Daily use".
There is water or fat stains on the
control panel. Clean the control panel.
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated. You put something on one or more
sensor fields. Remove the object from the sensor
fields.
The hob deactivates. You put something on the sensor
field .
Remove the object from the sensor
field.
Residual heat indicator does not
come on. The zone is not hot because it oper-
ated only for a short time or the sen-
sor is damaged. If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
Automatic Heat Up does not oper-
ate. The zone is hot. Let the zone become sufficiently
cool.
The highest heat setting is set. The highest heat setting has the
same power as the function.
The heat setting changes between
two levels. Power management operates. Refer to "Daily use".
The sensor fields become hot. The cookware is too large or you
put it too near to the controls. Put large cookware on the rear
zones if possible.
comes on.
Child Safety Device or Lock oper-
ates. Refer to "Daily use".
comes on.
There is no cookware on the zone. Put cookware on the zone.
The cookware is unsuitable. Use suitable cookware. Refer to
"Hints and tips".
The diameter of the bottom of the
cookware is too small for the zone. Use cookware with correct dimen-
sions. Refer to "Technical data".
13