Labels supplied with the accessories bag
Stick the adhesive labels as indicated below:
MOD.
PROD.NO.
SER.NO
DATA
MOD.
PROD.NO.
SER.NO
DATA
MOD.
PROD.NO.
SER.NO.
03 IT
MADE IN ITALY
TYPE
IP20
0049
A
B
C
A. Stick it on Guarantee Card and send this part (if
applicable).
B. Stick it on Guarantee Card and keep this part (if
applicable).
C. Stick it on instruction booklet.
Installation
Warning! Refer to Safety chapters.
Before the installation
Before you install the hob, write down the information
bellow from the rating plate. The rating plate is on the
bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble the hob
into correct built-in units and work surfaces that align to
the standards.
Connection cable
• The hob is supplied with a connection cable.
• To replace the damaged mains cable use the
following (or higher) mains cable type: H05V2V2-F T
min 90°C. Speak to your local Service Centre.
Attaching the seal
1. Clean the worktop around the cut out area.
2. Attach the supplied seal stripe to the lower edge of
the hob along the outer edge of the glass ceramic.
Do not extend it. Make sure that the ends of the
seal stripe are located in the middle of one side of
the hob.
3. Add some mm when you cut the seal stripe to the
length.
4. Push the two ends of seal stripe together.
28
