background image

17

CUSTOMER SERVICE AND SPARE PARTS

opening is not obstructed (see “Defrosting”
section).

If your appliance is still not working properly after
making the above checks, contact the nearest
service centre.

To obtain fast service, it is essential that when you
apply for it you specify the model and serial number
of your appliance which can be found on the
guarantee certificate or on the rating plate located
inside the appliance, on the bottom left-hand side.

Defrosting

The freezer compartment, however, will become
progressively covered with frost. This should be
removed with the special plastic scraper provided,
whenever the thickness of the frost exceeds 4 mm.
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.

However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
as follows:

1. pull out the plug from the wall socket or turn the

thermostat knob to the «O» setting;

2. remove any stored food, wrap it in several layers

of newspaper and put it in a cool place;

3. leave the door open, and insert the plastic

scraper in the appropriate seating at the bottom
centre, placing a basin underneath to collect the
defrost water.

4. when defrosting is completed, dry the interior

thoroughly; keep the scraper for future use;

5.  turn the thermostat knob back to the required

setting or replace the plug in the power socket,
turn fast freezing knob to “S”.

6.  After two or three hours, reload the previously

removed food into the compartment and let it run
in normal operation.

D068

Important: 

Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.

Do not use a maechanical device or any artificial
means to speed up the thawing process other
than those recommended by the manufacturer.

A temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.

If the appliance is not functioning properly, check
that:

the plug is firmly in the wall socket and the mains
power switch is on;

there is an electricity supply (find out by plugging
in another appliance);

the thermostat knob is in the correct position.

If there are water drops on the bottom of the
cabinet, check that the defrost water drain

Summary of Contents for FR 200










Reviews: