(0,5s)
(0,5s)
10s
1s
~5s
~5s
max 300s
(0,5s)
(0,5s)
(0,5s)
(0,5s)
(0,5s)
Monostable
1. Press and hold the remote control button you want to assign to a channel
2. Press the PROG button briefly (0.5s) - STATUS LED lights up blue (programming channel 1
button). To assign the button to the second channel, wait about 5 s until the STATUS LED lights
up red.
3. Release the remote control button.
4. STATUS LED will turn off and then light up again.
5. Press briefly the remote control button again.
6. After the button has been correctly assigned, the STATUS LED will flash 3 times and the con-
troller will exit the programming mode.
PROGRAMMING DELAY TIME USING PROG BUTTON
• The default “Delay time” is set to 10 s.
• The time is programmed only for buttons assigned to “partial opening of a gate”.
1. Press the PROG button briefly (0.5s) – STATUS LED light up blue.
2. Wait approximately 10 seconds for the STATUS LED to light up cyan.
3. Briefly press the remote control button you previously assigned to partial opening of a gate
mode.
4. The output to which the button is assigned will be activated briefly. STATUS LED will flash at 1
s intervals.
5. After setting time (maximum 300 s), press the remote control button again.
6. The output will be activated, the STATUS LED will flash 3 times and the receiver will exit the
time programming mode.
REMOVING ASSIGNED REMOTE CONTROL BUTTONS USING PROG BUTTON
1. Press the PROG button for about 5 seconds – STATUS LED lights up orange.
2. When STATUS LED lights up blue, release the PROG button
3. While STATUS LED is light up blue, briefly press the remote control button you want to remove
from channel 1.
4. If you want to remove the button from channel 2, wait about 5 seconds until the STATUS LED
lights up red. While STATUS LED is light up red, briefly press the remote control button you
want to remove from channel 2.
5. STATUS LED flashes orange 3 times and the receiver exits the mode.
channel 1
channel 2
