4) Installing the VGA Water Block
Place the VGA Water Block and the clip on
the center of the VGA chipset. Screw each
bolt B on each nipple slightly, and tighten
each bolt B a few turns at a time while
alternating between the two until the Clip
ends are completely pressed against the
Nipples.
Notes)
Make sure that the Water Block’s base
and the VGA Chipset are completely in
contact with each other.
5) Installing the VGA Card
Insert the assembled VGA card into the
motherboard’s AGP (or PCIe) slot. Use the
Fixing Bolt to fix the VGA card on to the
computer case. If the VGA card has an on-board
power connector, remember to plug in the
power cable.
6) Installing the Tubes and the Tube Clamps
Plug the tubes over the VGA Water Block’s
fittings and install the Tube Clamps.
Note 1)
Use a proper tool (e.g. cutting nipper)
when installing the Tube Clamps.
Note 2)
Hold the VGA Water Block with one hand
while installing the Tube Clamps so that
the Water Block does not move around.
※
The specifications of any product may change without prior notice to improve performance.
5
Bolt B
Clip
Nipple
VGA Chipset
Fixing Bolt
Tube
Tube Clamp