※
The specifications of any product may change without prior notice to improve performance.
3
RAM Heatsink
VGA RAM
VGA Chipset
Thermal
Tape
Film
Nipple
Washer
Mounting
Hole
Washer
Bolt B
5. Components
1) Attaching the VGA RAM Heatsinks
Remove the film from the Thermal Tapes
on the bottom of the RAM Heatsinks and
attach the Heatsinks on the VGA RAM.
Note1)
If thermal grease or other residue
remains on the RAM, the Thermal
Tapes will not stick.
Clean the surface of the RAM with
acetone or alcohol before attaching.
Note 2)
The bonding strength of the Thermal
Tape reaches 90% after 24 hours
of curing.
Do not put excessive force on the
RAM Heatsinks during this period.
Note 3)
Thermal Tapes lose adhesiveness
after it has been used for attachment
once and cannot be reused.
Purchase Thermal Tapes separately
for future reattachments.
2) Installing the Nipples
As shown in the diagram, install the Nipple
and Bolt B on the Mounting Hole with a
Washer in between on both sides of the
VGA card. Use only the supplied Washers.
Make sure to check the VGA card's correct
Nipple installation hole position to install
properly.