COMMAND
MEANING
USE
PWD=[New
password]
Change password to
[new password]
[password]
└─┘
PWD=1234
SEN=[value]
[value] defines sensibility (acceleration or
vehicle inclination) that will trigger alarm.
In general, the lower the value is, the
higher is the sensitivity.
Allowed range:
3 to 100.
Factory default
value is 5. Recommended value is lower
then 12.
[password]
└─┘
SEN=7
REL=[parameter]
[parameter] defines, which function is
relay due to operate. Allowed parameters
are:
OFF
– Relay permanently switched off
ON
– Relay permanently switched on
ALARM
– Relay is switched on for 28
seconds during alarm, if you switch-off
RELAY it will disarm, too.
STATUS
– Relay switched off while alarm
is arming and switched on while
disarming . (It copy status of arming)
[password]
└─┘
REL=ALARM
AT=[value]
[value] specifies the
Arrival time,
that is
time from turning of the ignition key till
attaching RFID tags to the reader. If this
time is missed, alarm triggers.
Command is also used to define the delay
of external alarm input nr. 2.
Allowed range:
3 to 120 seconds.
[password]
└─┘
AT=15
DT=[value]
[value] specifies
Departure time
, during
that it is necessary to leave the vehicle at
arming mode. Allowed range:
3 to 120
seconds.
[password]
└─┘
DT=30
?S
Command must be placed at the end of
SMS. After receiving this command Car
alarm will send back actual setting of text
reports.
[password]
└─┘
?S
?P
Command must be placed at the end of
SMS. After receiving this command Car
alarm will send back information about
actual vehicle location.
[password]
└─┘
?P
?
Command must be placed at the end of
SMS. After receiving this command Car
alarm will send back actual setting T1 to
T4, SEN, REL, AT, DT
[password]
└─┘
?
RESET=YES
Command will delete current settings and
telephone numbers and will set device to
default settings
[password]
└─┘
RESET=YES
WEB
After receiving this command Car alarm
will send back to you access data to
register at web portal www.gpsasistent.sk
[password]
└─┘
WEB
Example:
To set
sensibility of inclination detector write and send following SMS message:
6
