ZA
CU
TO
PROD
UC
T
IN
S TRUCTION
S
Z
Parts & Features
Sony FS7 Recoil Kit
Compatible with the Sony FS7 this Recoil shoulder-mounted
rig includes our VCT Universal baseplate, the Rosette
Mini-mount for the Sony FS7 handgrip, and our Axis Mini for
Sony FS7 which can be used with either the Gratical HD or
the Sony monitor. Centered around the Universal VCT
Baseplate, this kit allows you to transfer your rig from tripod
to shoulder in seconds.
For additional assembly and individual component features, see numerical figures.
Figure 1:b
Adjusting Rods
Figure 1:d
Adjusting Rods
Attach rods to VCT Plate by loosening
ratcheting levers, sliding rods into place
and then re-tighten levers.
Figure 1:c
Mounting VCT Plate to VCT-14 Tripod Quick Release Plate
(VCT-14 Sold Separately)
If needed the tail hook position can be raised or lowered.
Loosen both allen screws equally, raise or lower tail hook
and relock both allen screws when in desired position.
Pull red lever on VCT-14 to release
your Universal VCT Plate.
Mount VCT Plate to VCT-14 by sliding the front wedge into front slot
of VCT-14 and the tail hook around the rear knob of VCT-14.
The VCT-14 will click when the VCT Plate is locked into place.
An alternative mounting method when using a tripod
without a VCT14, is to mount your tripod’s quick release
wedge plate to the wedge on the bottom of the
Universal VCT Plate.
Adjust rod height by loosening both front
allen screws equally. Slide rods up or down
for desired position and re-lock allen screws.
From the bottom of the VCT Plate, screw the 1/4”-20 and 3/8”-16 mounting screw
into the bottom your camera.
Before securing in place, add on accessories to help find the true balance of your camera.
Align both the VCT and camera’s center of balance and secure mounting screw in place.
Figure 1:a
Mounting Camera
VCT Universal Baseplate Center of Balance
1
2
1
Universal VCT Baseplate
*
Tail Hook
VCT Wedge Plate
15mm Rods
3/8”-16 Mounting Screw
1/4”-20 Mounting Screw
Ratcheting Levers
Rod Clamp Riser
Rear Rod Ports
Side 1/4”-20 Mounting Holes
2
1
1
1
1
2
1
2
5/32 & 9/64 Allen Wrench
1
2
1
2
1
Rosette Mini Mount
15mm Rod Ports
Ratcheting Lever
Rosette Mounts
1
1
3
1
Axis Mini
3” Mounting Rod
Tightening Knobs
EVF Rosette Mount
EVF Rosette Mount
Left Loose
Right Tight
Pull knob out
to reposition.
LEFT LOOSE
RIGHT TIGHT
Lever Usage
1
1
2
15mm Rod Port
Ratcheting Lever
Mounting Screws
1
1
2
Front Rod Mount
with Mounting Screws
15mm Rod Port
Ratcheting Lever
Sony FS7 & Axis Mini Mount
Figure 1
Figure 2
Figure 3
Align and remount allen screws to VCT
body. Adjust to desired height and
re-lock allen screws.
Flip front rods over from original position.
Remove both allen screws and separate
front jeep with rods from VCT body.
For Red Epic/Scarlet flip the rod clamp riser.
1
2
3
Camera Center of Balance
